Miranda Kaleido-X16 Provozní pokyny stáhnout pdf (Strana 15)

Kaleido-X16

Quick Start Guide

2 Position the Kaleido-X16 frame at the designated location within the rack, and secure

the front of the frame to the rack by using suitable screws and washers (not included).

Powering up the Kaleido-X16

To power up the Kaleido-X16

1 Plug the power cord(s) from the Kaleido-X16 into a grounded power outlet.

2 Press the power button at the front of the frame (behind the front cover).

The startup sequence takes a couple of minutes. The startup is completed when the

CPU LED is solid green.

Setting up the Kaleido-X16 Hardware

To set up the Kaleido-X16 hardware

1 Make the required network and other connections to your Kaleido-X16 (see Cabling

Diagram, on page 8). Connect a client PC, the Kaleido-RCP2 (if available), and an Audio

Bridge Terminal (if available) to a dedicated 100Base-T Ethernet switch. You can also

connect a mouse and a keyboard to your Kaleido-RCP2.

IMPORTANT

Mobile Installation

If you are deploying your Kaleido-X16 in a mobile unit, it is your responsibility

to make sure the back of the multiviewer is securely attached to the rack. For

instance you may install a blank panel at the back of the rack, so that it meets

the top of the frame, to prevent the frame from bouncing away from the

support brackets.

Ventilation

For proper ventilation, make sure the front and side panel air vents are not

blocked and the air filter is clean.

IMPORTANT

• If you only have one PSU, make sure you plug your power cable into the

power connector on the right side of the rear connector panel (as you face

the rear of the frame). This should be on the same side of the frame as the

one PSU you have installed. If you do not do this, your system cannot draw

power.

• If you have two PSUs, make sure you plug in both power cables into both

power connectors of the rear connector panel. If you do not do this your

system cannot have PSU redundancy.

Power button

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 28 29

Žádné komentáře

Miranda Kaleido-X16 Provozní pokyny Strana 15