Miranda Kaleido-X Provozní pokyny stáhnout pdf (Strana 15)

Kaleido-X

Quick Start Guide

System Requirements for a Client PC

A client PC or laptop meeting the following requirements is required to access the XAdmin

Web client, and the other Kaleido-X client applications.

Step 1: Physical Setup

Setting up the Kaleido-X (7RU) Hardware

To set up the Kaleido-X (7RU) hardware:

1 With the Kaleido-X (7RU) frame (enclosure) installed in its designated rack position, and

before powering up the unit, verify that each card is securely seated in its slot.

The Kaleido-X has been configured to automatically detect the resolution of any

connected display. If the required information is not available, then a fall-back

resolution of 1280 × 1024 @ 60 Hz is used.

2 Connect outputs of the Kaleido-X to one or more displays that support this resolution,

and connect one or more video sources to the frame (see

Cabling Diagram on page 7).

If you wish to use a different resolution, see Changing the Output Resolution below, for

detailed instructions.

3 Make the network and other connections as shown in the cabling diagram (see page 7).

Connect a client PC, the Kaleido-RCP2, one or more Audio Bridge Terminals, and every

output module to a dedicated 100Base-T Ethernet switch. You can also connect a

mouse and a keyboard to your Kaleido-RCP2.

Operating system Windows XP Professional, Windows 7, Windows 8, or Windows 8.1

Processor Core 2 Duo at 2 GHz, or better

Memory At least 2 GB of RAM

Disk space At least 2 GB free

IMPORTANT

There are two different models of 7RU frames, and two models of power

supplies. If you have a frame model KXA-FR7-B (with the corresponding

KXA-PSU-7-B power supply), you must ensure that a ground cable (not

included) is connected between the frame and the rack before powering

up the unit.

Connect a ground cable

and the rack

between this stud

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 38 39

Žádné komentáře

Miranda Kaleido-X Provozní pokyny Strana 15