Miranda Kaleido-X Provozní pokyny stáhnout pdf (Strana 27)

Kaleido-X

Quick Start Guide

For more information about the ABT, refer to the Audio Bridge Terminal Guide to

Installation and Operation, available on the DVD that shipped with your system.

To configure the IP address and other network settings of the ABT

1 Connect a PC to a switch.

2 Referring to Configuring a Client PC on page 14, configure the PC with the following

network settings:

3 Apply power to the Audio Bridge Terminal and make sure it is connected to the same

switch as the PC.

• If the switch is Power over Ethernet (PoE) enabled, simply connect it to the unit

using an Ethernet cable.

• If not, PoE mid-span (inserter) equipment must be placed between the switch and

the Audio Bridge Terminal.

4 Press the RESET button (located on the right-hand side of the ABT rear panel beside the

ETHERNET/POWER RJ-45 connector) for at least 1 second.

The Audio Bridge Terminal will reboot with the following static network configuration:

5 Using a Web browser on the PC, connect to the ABT using the following address:

10.0.3.190.

The home page of the ABT’s built-in Web server is displayed.

6Click Network Configuration (in the navigation pane).

The Network Configuration page is displayed.

DHCP OFF

Static IP address 10.0.0.1

Subnet mask 255.255.0.0

Default gateway 10.0.0.1

DHCP OFF

Static IP address 10.0.3.190

Subnet mask 255.255.0.0

Default gateway 10.0.0.1

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 38 39

Žádné komentáře

Miranda Kaleido-X Provozní pokyny Strana 27