Miranda Kaleido-X Provozní pokyny stáhnout pdf (Strana 37)

Kaleido-X

Quick Start Guide

Verifying the Kaleido-RCP2

To verify that the Kaleido-RCP2 is functioning normally:

• Log on to the Kaleido-RCP2 (see Using the Kaleido-RCP2 with Default Settings on

page 11), and then test various operations using the Kaleido-RCP2 keyboard and the

mouse (e.g. load a predefined layout).

Verifying the Audio Bridge Terminal

To verify that the ABT is functioning normally:

• Inspect the ACTIVITY and front panel LEDs on the unit to make sure there are no error

conditions:

The ACTIVITY indicator is located on the right-hand side of the rear panel. This LED

reports the status of the Ethernet connection as indicated in the table below.

Two LEDs are visible on the front panel, one for each power supply. When lit, they both

indicate the same status.

When the ABT is powered up, all three LEDs will be orange until the boot sequence is

terminated. This is a visual indicator that the LEDs are functioning properly.

RS-422 Connection Diagram

Each output card supports one RS-422 port over an RJ-45 connector. This port allows the

Kaleido-X to connect to external serial devices such as a router, production switcher, or

router controller.

The pinout for the RS-422 signals on the Kaleido-X16’s RJ-45 connectors, and the wiring

diagrams for the appropriate adapters, are shown here:

ACTIVITY Indicator on Rear Panel Power-Supply LEDs on Front Panel

Color Status Color Status

Off No link detected Green Normal

Green Normal (good link) Flashing green Normal, rebooting

Orange Activity Orange Warning

Red Hardware fault Flashing orange Warning, rebooting

Flashing red Upgrading firmware Red Hardware fault

Flashing red Upgrading firmware

Note: The Kaleido-X RS-422 ports each have an RJ-45 connector in order to

preserve space on a busy panel. The RS-422 interface specifies a DE-9

connector, so if you are using this interface, you will require a DE-9-to-RJ-45

adapter. Grass Valley supplies two adapter models, correctly wired for this

application: a straight adapter (part no. 1737-3000-102), and a crossover

adapter (part no. 1792-3700-100).

1 2 ... 32 33 34 35 36 37 38 39

Žádné komentáře

Miranda Kaleido-X Provozní pokyny Strana 37