Miranda Kaleido-X16 Instalační manuál stáhnout pdf (Strana 17)

Kaleido-X16

Hardware Description & Installation Manual

Frame Cooling Fans

Air intake for the frame is handled by six fans located near the front of the frame and two heat sinks near

the rear of the frame. The fans draw air into the frame through a grille and filter in the front door. The heat

sinks help to exhaust air out through grates on either side (see diagram, above).

Power Supply Cooling Fan

Each PSU has one fan located on its front. Each PSU draws air through the frame’s front grille, through the

PSU, then out to the closest rear fan to be exhausted out the side of the frame (see diagrams, above and

below):

Air Filter

Cooling air drawn into the Kaleido-X16 frame by the ventilating fans passes through a filter located behind

a grille in the front door of the frame.

CompactFlash

In order to boot the CPU, you must ensure the appropriate CompactFlash (CF) card is properly inserted in

the CF slot (accessible from the front of the Kaleido-X16 frame). The CF card contains the operating system

required for a system boot.

IMPORTANT: The Kaleido-X16 frame requires a constant flow of cooling air during operation. DO NOT OPERATE

THE UNIT IF THESE FANS ARE NOT WORKING. If a fan is not working contact your next level of

support.

See also: For more information about cleaning the air filter, see “Cleaning the Air Filter” on page 24.

PSU fan on front of PSU A

CF slot on front of Kaleido-X16 frame

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 81 82

Žádné komentáře

Miranda Kaleido-X16 Instalační manuál Strana 17