Miranda Kaleido-X16 Instalační manuál stáhnout pdf (Strana 41)

Kaleido-X16

Hardware Description & Installation Manual

When you change the DHCP mode, the device must be restarted for the new option to take effect. This is

done automatically but only after you exit the Configuration menu. You can make other changes using

the Configuration menu, and only exit, once you are done with the changes.

Setting an IP Address, Subnet Mask and Gateway

The table below shows how to set a fixed IP address for a Kaleido-RCP2 unit. As an example, the IP address

will be changed from 10.0.3.191 to 192.168.0.10. This task is performed by using the Configuration

menu.

Action LCD indication Other Buttons

Press and hold the ENTER key for at least

8 seconds to access the Configuration

menu.

At the end of the 8 seconds:

Configuration

ROOM SELECTION

Digit keys 2 (UP) and 8 (DOWN), and the

ENTER and ESC buttons, are lit; other

digit keys are dimmed.

Press 8 once to go to the ETHERNET

OPTIONS submenu.

Configuration

ETHERNET OPTION

Press ENTER to open the Ethernet

parameter menu.

ETHERNET OPTIONS

DHCP

Press ENTER again to see the current

DHCP status.

DHCP

ENABLE

Press 8 to go to the DISABLE option.

(Press 2 to go back to the previous

selection.)

DHCP

DISABLE

Press ENTER to select this option, or press

ESC to cancel. In either case, you will

return to the previous menu level.

ETHERNET OPTIONS

DHCP

Press ESC twice to exit the

Configuration menu.

Note: If you changed the DHCP

parameter, the Kaleido-RCP2 unit will

reboot.

RMC All buttons are dimmed.

Note: The method is the same for the Subnet Mask and Gateway menus.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 81 82

Komentáře k této Příručce

Žádné komentáře

Miranda Kaleido-X16 Instalační manuál Strana 41

Komentáře k této Příručce

Související produkty a manuály pro Procesory Miranda Kaleido-X16