Miranda Kaleido-X16 Instalační manuál stáhnout pdf (Strana 57)

Kaleido-X16

Hardware Description & Installation Manual

When the ABT is powered up, all three LEDs will be orange until the boot sequence is terminated. This is a

visual indicator that the LEDs are functioning properly.

Controls

The RESET button is located on the right-hand side of the ABT rear panel.

Push the RESET button to reset the ABT's IP address to a default value:

• IP address:10.0.3.190

• Subnet mask:255.255.0.0

This simplifies the process of connecting to the ABT via its Ethernet connection.

Operation

Synchronization

An external reference signal is required to synchronize the SDTI outputs. An analog video reference signal,

word clock or AES-75 signal can be connected to one of the REFERENCE SIGNAL connectors. If the loop-

through is not used, a 75 ohm termination on the other REFERENCE SIGNAL connector must be used to

properly terminate the line.

For an Audio Bridge Terminal with an AES breakout panel, AES INPUT 1 can also be used for

synchronization. This input signal must be error-free PCM audio sampled at 48 kHz. In the case where both

REFERENCE SIGNAL and AES INPUT 1 have valid references, the signal connected to REFERENCE SIGNAL has

priority.

SDTI Link

The two SDTI outputs are identical, each including signals from all inputs. Each SDTI output can be

connected to a Kaleido-X16 input module or to a specific SDTI de-multiplexer. Depending on the number

Orange Warning

Flashing Orange Warning, rebooting

Red Hardware fault

Flashing Red Upgrading firmware

See also: For more information about connecting to the ABT with a Web browser, see “Web Interface” on

page 52.

Color Board Status

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 81 82

Žádné komentáře

Miranda Kaleido-X16 Instalační manuál Strana 57